《沒有幻燈片標題-哈爾濱工程大學物理實驗教學中心》由會員分享，可在線閱讀，更多相關《沒有幻燈片標題-哈爾濱工程大學物理實驗教學中心（14頁珍藏版）》請?jiān)谘b配圖網上搜索。
1、聲速的測量與示波器的使用 理學院 Determining the Velocity of Sound and Using the Oscilloscope 聲速的測量與示波器的使用 理學院 1.Purpose: Understand the relationship between the sound speed and the air state parameters Understand the function of the piezoelectricity transducer. Understand deeply the theory of standing waves and vi
2、brating interfering Mastering the using of the oscilloscope. Mastering a method of measuring sound speed. 聲速的測量與示波器的使用 理學院 2.Principle: (1) sound speed in theory is expressed as (1) In the formula (1), T0=273.15 K， t is condition temperature, formula (1) can be used to calculate the sound speed in a
3、ir. (2) the theory of sound speed measuring By the relationship between speed v frequency f and wavelength : v=f (2) so when we measure out f and , we can calculate v by formula (2). The instruments are showed in Fig.1. 00 0 145.3311 T t T t vv Fig.1 Instruments used to measure 聲速的測量與示波器的使用 理學院 The
4、transducer S1 is used to emit sound wave . The transducer S2 is used to receive sound wave. When the standing wave appears, the sound wave received by S2 is strongest, and the phenomena can be displaced by the oscilloscope. A standing wave pattern is an interference phenomenon. It is formed as the r
5、esult of the perfectly timed interference of two waves passing through the same medium. A standing wave pattern is not actually a wave; rather it is the pattern resulting from the presence of two waves of the same frequency with different directions of travel within the same medium. 聲速的測量與示波器的使用 理學院
6、 One characteristic of every standing wave pattern is that there are points along the medium which appear to be standing still. These points, sometimes described as points of no displacement, are referred to as nodes. There are other points along the medium which undergo vibrations between a large p
7、ositive and large negative displacement. These are the points which undergo the maximum displacement during each vibrational cycle of the standing wave. In a sense, these points are the opposite of nodes, and so they are called antinodes. A standing wave pattern always consists of an alternating pat
8、tern of nodes and antinodes. The animation shown below depicts a rope vibrating with a standing wave pattern. The nodes and antinodes are labeled on the diagram. When a standing wave pattern is established in a medium, the nodes and the antinodes are always located at the same position along the med
9、ium; they are standing still. It is this characteristic which has earned the pattern the name standing wave. 聲速的測量與示波器的使用 理學院 The positioning of the nodes and antinodes in a standing wave pattern can be explained by focusing on the interference of the two waves. The nodes are produced at locations w
10、here destructive interference occurs. For instance, nodes form at locations where a crest of one wave meets a trough of a second wave; or a half-crest of one wave meets a half-trough of a second wave; or a quarter-crest of one wave meets a quarter-trough of a second wave; etc. Antinodes, on the othe
11、r hand, are produced at locations where constructive interference occurs. For instance, if a crest of one wave meets a crest of a second wave, a point of large positive displacement results. Similarly, if a trough of one wave meets a trough of a second wave, a point of large negative displacement re
12、sults. 聲速的測量與示波器的使用 理學院 Antinodes are always vibrating back and forth between these points of large positive and large negative displacement; this is because during a complete cycle of vibration, a crest will meet a crest; and then one-half cycle later, a trough will meet a trough. Because antinodes
13、 are vibrating back and forth between a large positive and large negative displacement, a diagram of a standing wave is sometimes depicted by drawing the shape of the medium at an instant in time and at an instant one-half vibrational cycle later. This is done in the diagram below. 聲速的測量與示波器的使用 理學院
14、Nodes and antinodes should not be confused with crests and troughs. When the motion of a traveling wave is discussed, it is customary to refer to a point of large maximum displacement as a crest and a point of large negative displacement as a trough. These represent points of the disturbance which t
15、ravel from one location to another through the medium. An anti-node on the other hand is a point on the medium which is staying in the same location. Furthermore, an anti-node vibrates back and forth between a large upward and a large downward displacement. And finally, nodes and antinodes are not a
16、ctually part of a wave. Recall that a standing wave is not actually a wave but rather a pattern which results from the interference of two or more waves. Since a standing wave is not technically a wave, an anti-node is not technically a point on a wave. The nodes and antinodes are merely unique poin
17、ts on the medium which make up the wave pattern. The distance between two continuous antinodes or two continuous nodes is /2. So we can get by measuring the distance. 聲速的測量與示波器的使用 理學院 3.Devices: ZKY-SSA sound speed measuring instrument 聲速的測量與示波器的使用 理學院 COS5020B oscilloscope 聲速的測量與示波器的使用 理學院 XD-7S si
18、gnal generator 聲速的測量與示波器的使用 理學院 1.frequency： f= 0.05 kHz; f=0.05 kHz 2.wavelength： 聲速的測量與示波器的使用 理學院 110 )( 110 )( 2 30,10 21,1 2 1 10 ji ij n i i Sxx A 10210210 BA fv 22 )()( ffE r rE vv vvv (1)10 type A error ： (3)10 error： (4) =(Sj-i 10)/10= mm (2) (3) (4) mm (2)10 type B error： 2i2i10 B 0.028mm mm 3.calculating sound speed： = m/s % = m/s m/s (1) 聲速的測量與示波器的使用 理學院 00 0 )5.16(145.3311 TT t t vv paring the theory speed and experiment speed： (2) = m/s (3) = % (1) = m/s vvv t %100/ tvvrE
沒有幻燈片標題-哈爾濱工程大學物理實驗教學中心
